Servicing Perth & the Peel region · 17 Pinjarra Road, Mandurah WA 6210

← Back to the blog

Can You Install a Split System on a Brick Wall? Perth Installs Explained

21 November 2026

By the My HVAC Experts team

Split system air conditioner display showing 22 degrees

Perth is known for double brick homes. People sometimes worry that installing a split system through brick is difficult or messy. It’s actually very common, and experienced installers do it every day. Here’s what’s involved.

Drilling through brick

Installers use a core drill to cut a neat round hole through both layers of brick for the pipes, cable and drain. The hole is angled slightly downward toward the outside so condensate drains properly.

Mounting the indoor unit

The mounting plate is fixed securely to the internal brick wall using appropriate fixings. Brick provides a strong base for wall-mounted units.

Outdoor unit on brick

Outdoor units can be mounted on brackets fixed to the external brick wall, or placed on a ground pad. Brick walls generally provide a solid base for brackets.

Dust and mess

Core drilling creates dust, but installers use dust sheets, vacuums and water to keep it under control. Clear the area around the wall before installation.

Sealing the hole

Once pipes are through, the gap around them is sealed to keep out drafts, water and pests.

Rendered or painted walls

Rendered or painted external walls can be drilled neatly. Pipe covers can be painted to match.

Where brackets and fixings go

Indoor units mount on a bracket fixed to the wall with masonry anchors. Outdoor units are usually placed on a ground slab or mounted on wall brackets. In double brick homes, both are routine. The installer checks for any cables or pipes in the wall before drilling.

Rendered and painted walls

Many Perth homes have rendered or painted brick. Core drilling leaves a neat hole, and the penetration is sealed after installation. Duct covers on the outside can be painted to match the render.

Double brick and cavity walls

Most Perth homes built from the 1960s onwards are double brick, with two layers of brick and a cavity between them. Installers use a core drill to cut a clean hole through both layers. The pipe and drain are run through a sleeve, and the hole is sealed to keep out water, insects and draughts.

Limestone and older homes

Some older homes, particularly around Fremantle, have limestone walls. These can be installed through too, but need care, as limestone can be softer and more variable. The installer will assess the wall before drilling.

Getting a quote

We’ll check your walls and recommend the best location and pipe route.

Sealing and weatherproofing

After the pipes go through, the hole is sealed inside and out. This keeps out water, insects and draughts.

Other wall types

We also install split system air conditioning on brick veneer, timber frame and other construction types. We’ll check your walls during the assessment.

Got a brick home?

Call My HVAC Experts on 08 6156 7042. We install split systems in Perth brick homes every week.

Related reading: Ducted Reverse Cycle Air Conditioning: A Perth Homeowner’s Guide

Frequently asked questions

Can split systems be installed on double brick walls?

Yes. It’s very common in Perth.

Is drilling through brick messy?

It creates some dust, but installers use dust sheets and vacuums to minimise mess.

Will the hole be sealed?

Yes. The gap around pipes is sealed to keep out drafts, water and pests.

Can outdoor units be mounted on brick?

Yes, on secure brackets or a ground pad.

Do you install on other wall types?

Yes, including brick veneer and timber frame.

HV

My HVAC Experts

Perth and Peel air conditioning and heat pump specialists based at 17 Pinjarra Road, Mandurah. Honest advice, correctly sized systems and tidy installs. Call 08 6156 7042.

Want it sized for your home?

We assess your home first, then recommend a system that fits.

Request a Quote →

On this page

    Share this article